STEP1 : 3D Design on computer

STEP2 : Wax printing from computer using RP printing machine

hand wax modeling to adjust details (in some cases we do all by hand)

hand wax modeling

STEP3 : Casting of Silver Master mold

STEP3 : Casting of Silver Master mold

STEP4 : Make the Rubber mold imprint from the Master allows future replication

STEP5 : Casting gold, Shrinkage occurs, we can now mesure theexcat size of stones needed

SETP6 : Sorting, recutting, groving. Each stone need a gutter to grab it from underneath, and the size must be exact to 0.01 mm precision. We recut every stone.

STEP7 : Invisible setting an start under binoculars

STEP7 : Invisible setting

STEP7 : Invisible setting. Always start from center to the outter direction

STEP7 : Invisible setting. Always start from center to the outter direction

STEP7 : The bottom of the bangle is pave set to resist chocks better.

Invisible setting / Pave setting

Pave setting

Invisible setting close-up

Depending on how much the budget is the top facets might show slight variation in size

Because when we recut to precision we chose from a stock going from 1.9 mm to 2.1 mm

And we put all stones to be 2.0 mm so te bigger stones will show a large table facet.

STEP8 : Polishing

STEP9 : Assembling and Rhodium plating

Rhodium plating will give the chromium effect to white gold.

Gold is a yellow metal. White gold 18k is an allow using gold and paladium, naturally tinted with yellow (off-white).